D1260/D1260B Owner's Manual Part III: Advanced Commands - SERVICE MENU ? (9 + 9 + Enter)
If you know the point number, you can enter it by pressing its number key and then the ENTER key.
The display will change to show the point that was entered. If the point is invalid the message “Invalid Point” or “This is not a valid walk point” appears.
Test each point by first opening and then closing the door or window or other detection device.
Check the display after testing each point. For interior points, walking past the device once is sufficient. If any point does not test correctly, contact your security company for service.
2.During the Walk Test you may want to see the points that remain untested by pressing the View untested pts> soft key.
The display shows ### pts untested.
Press the Point information> soft key to see information about specific points that have not yet been tested.
The display changes to show the information for that point.
Move through this list by pressing the Next Point> soft key.
Press the <Exit soft key to return to the ###
points remain to be tested. before continuing the Service Walk Test.
3.When all points have been tested, 0 points remain to be tested is displayed.
Press the <Exit soft key.
The display momentarily shows All points have been tested.
before returning to idle text.
Using Default Text
This function allows the current state of the area for 3 seconds before returning to idle text.
1.Press the Default Text?> soft key to display the current state of the area.
2.The current state of the area is displayed for 3 seconds before returning to idle text.
Using Setup
The Setup function is accessed by pressing the Setup?
>soft key.
The adjustable functions that are available in this menu are:
•High Brightness,
66 | Bosch Security Systems 9/04 50410D |