D1260/D1260B Owner's Manual Part II: System Commands - WALK TEST ? (COMMAND + 4 + 4)
If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the MENU> soft key to enter the
Command Menu.
Press NEXT> soft key repeatedly.
When you reach the WALK TEST ?> prompt, press its adjacent soft key.
Press ENTER.
4.The burglary bell sounds for 2 seconds. When the display shows ### points remain to be tested (### is the number of points) you can begin.
If you know the point number, you can enter it by pressing its number key and then the ENTER key
The display will change to show the point that was entered. If the point is invalid the message “Invalid Point” or “This is not a valid walk point” appears.
Test each point by first opening and then closing the door or window or other detection device.
Check the display after testing each point. For interior points, walking past the device once is sufficient. If any point does not test correctly, contact your security company for service.
5.During the Walk Test you may want to see the points that remain untested by pressing the View untested pts> soft key.
The display shows ### points untested.
Press the Next Pt> or Prev Pt> soft keys to see information about specific points that have not yet been tested.
6.Move through this list by pressing the Next Pt> soft key.
The display changes to show the information for that point.
Press the Exit> soft key to return to the ###
points remain to be tested screen before continuing with the walk test.
7.When all points have been tested, 0 points remain to be tested is displayed.
Press the <Exit soft key.
The display momentarily shows All points have been tested.
The displays then shows idle text.
26 | Bosch Security Systems 9/04 50410D |