MIC612 Thermal Camera | Getting Started en 35 |
|
|
–
–
To set an address for a camera without an address:
1.Select the camera number that you want to FastAddress. The system displays the camera number on the keyboard and the image on the corresponding monitor.
2.Press
3.Press
4.Follow the
To change or clear an address for a camera with an address:
1.Select the camera number that you want to FastAddress. The system displays the camera number on the keyboard and the image on the corresponding monitor.
2.Press
3.Press
4.Follow the on screen instructions. You receive an
The table below identifies the setting of the thermal camera when you change the address of the optical camera.
Default Address, Optical | New Address, Optical Camera | Address, Thermal Camera |
0 | A number other than 0 | The number of the optical |
|
| camera + 1 |
A number other than 0 | 0 or another number |
|
You can change the address of the thermal camera via CTFID; there is no Aux code for this.
5.4.3FastAddress, Pelco Protocols
This section provides instructions to set a FastAddress with a Pelco keyboard or controller.
– The optical camera of the MIC612 with an address set to 0 responds to commands set to any address.
–
–
NOTICE!
A
To set FastAddress with a Pelco Keyboard:
1.Press and hold
2.Move the joystick to select the Command Lock menu.
3.Press the FOCUS or the IRIS button to turn Command Lock to OFF.
4.Move to the FastAddress menu and press the FOCUS button or the IRIS button to open the menu.
Bosch Security Systems, Inc. | Installation Manual | F.01U.249.416 2.0 2012.09 |