32 en Getting StartedMIC612 Thermal Camera
5.3.2 | Navigating the | |
| The OSD menus provide access to the programmable settings of the camera. The OSD | |
| displays only the submenus that are applicable to a particular MIC configuration. Some menu | |
| items (indicated as (L)) are locked and require a system password to use. Menu items marked | |
| with an asterisk (*) are default factory settings, unless otherwise noted. | |
|
| |
| NOTICE! | |
| After 4.5 minutes of inactivity, the OSD menu times out and exits without warning. Some | |
| unsaved settings in the current menu can be lost. | |
|
| |
| To navigate the OSD menus: | |
| 1. | Use the joystick to highlight a menu item. |
| 2. | Press either the Focus or the Iris key to open a menu item. |
| 3. | Follow the |
| Note: To select the Exit Menu item from anywhere in the current menu, use the Zoom | |
| command. | |
5.3.3 | Keyboard Commands, Bosch Protocol | |
| Keyboard control commands are composed of a sequence of three (3) inputs with the | |
| following convention: 1) a Function key + 2) a Command number key(s) + 3) the Enter key. | |
| – | Depending on the type of keyboard, the control function keys are labeled: |
|
| ON or AUX ON |
|
| OFF or AUX OFF |
|
| SET or SET SHOT |
|
| SHOT or SHOW SHOT |
NOTICE!
The convention used for control key commands in this manual is ON, OFF, SET, and SHOT. Refer to your keyboard manual for the key naming conventions.
–Command numbers range from 1 to 999. See Section A Keyboard Commands By Number for a complete list of keyboard commands for Bosch protocol.
–The Enter key can also be labeled with the ∞ symbol.
For example, the keyboard command to make the MIC612 pan 360º continuously is:
5.3.4Keyboard Commands, Pelco Protocol
Pelco control commands are composed of a sequence of two (2) keyboard inputs with the following convention: 1) a Command Number and 2) a Function key input.
The MIC612 uses the PRESET command key to save and recall presets
NOTICE!
To save a preset, enter the desired number and hold the PRESET key for approximately two
(2) seconds. To recall a preset, enter the desired preset number (or command) and momentarily press and release the PRESET key.
F.01U.249.416 2.0 2012.09 | Installation Manual | Bosch Security Systems, Inc. |