Bosch Appliances MIC612 installation manual 4.4.5, LED Description

28 en Installation MIC612 Thermal Camera

29.After wiring is complete, connect the power supply to the power source.

30.Verify that the following LEDs are lit:

LED Description

LED 2 18 VAC power on to camera

LED 4 Power on for optional heater

LED 3 18 VAC power on camera

LED 5 Power on for optional heater

31.Re-attach the enclosure lid and tighten the four (4) captive screws on the cover door to ensure that the enclosure is watertight.

4.4.5	Commissioning the Camera with Heater Option Fitted
	To enable the heaters, you must change two links on the printed circuit board (PCB) of the
	power supply. Follow these steps:
	1.	Disconnect the power supply from the power source.
	2.	Locate Link 1 and Link 2 on the PCB, next to terminal block HD6. The default setting is
		0V.

Figure 4.9 PCB links set to 0V

3.Break the two solder links and remove any excess solder.

4.Solder the links, using TCW link wire, from the left hand pads to the middle pads. The power supply will now deliver 18 VAC to terminal block HD6.

Figure 4.10 PCB links set to 18V

F.01U.249.416 2.0 2012.09 Installation Manual Bosch Security Systems, Inc.