Bosch Appliances MIC612 Thermal Camera, Safety en, Bosch Security Systems, Inc, F.01U.249.416

MIC612 Thermal Camera Safety en 7

CAUTION!

TO REDUCE THE RISK OF ELECTRIC SHOCK, DISCONNECT THE POWER SUPPLY BEFORE OPENING THE POWER SUPPLY UNIT.

POWER DISCONNECT: POWER SUPPLY UNITS HAVE POWER SUPPLIED WHENEVER THE POWER CORD IS INSERTED INTO THE POWER SOURCE.

WARNING!

INSTALLATION SHOULD BE CARRIED OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE NATIONAL ELECTRIC CODE, ANSI/NFPA, CANADIAN ELECTRIC CODE, AND ALL LOCAL COUNTRY CODES.

BOSCH SECURITY SYSTEMS ACCEPTS NO LIABILITY FOR ANY DAMAGES OR LOSSES CAUSED BY INCORRECT OR IMPROPER INSTALLATION.

WARNING!

INSTALL EXTERNAL INTERCONNECTING CABLES IN ACCORDANCE WITH NEC, ANSI/NFPA70 (FOR US APPLICATION) AND CANADIAN ELECTRICAL CODE, PART I, CSA C22.1 (FOR CAN. APPLICATION), AND IN ACCORDANCE WITH LOCAL COUNTRY CODES FOR ALL OTHER COUNTRIES. BRANCH CIRCUIT PROTECTION INCORPORATING A 20 A, 2-POLE LISTED CIRCUIT BREAKER OR BRANCH RATED FUSES ARE REQUIRED AS PART OF THE BUILDING INSTALLATION. A READILY ACCESSIBLE 2-POLE DISCONNECT DEVICE WITH A CONTACT SEPARATION OF AT LEAST 3 mm MUST BE INCORPORATED.ROUTING OF EXTERNAL WIRING MUST BE DONE THROUGH A PERMANENTLY-EARTHED METAL CONDUIT.

WARNING!

THE CAMERA MUST BE MOUNTED DIRECTLY AND PERMANENTLY TO A NON-COMBUSTIBLE SURFACE.

1.Install according to the manufacturer’s instructions.

2.Do not install near any heat sources such as furnaces, radiators, heaters, stoves, or other equipment (including amplifiers) that produce heat.

3.Do not install the camera’s power supply near water (for example, near a bathtub, washbowl, or swimming pool).

4.Use common sense safety precautions, especially during installation where there could be risk of injury if the camera is dropped or falls.

5.Do not open the camera unit. Doing so will void the warranty.

6.Use only the power source indicated in this manual. Ensure that the rating of current of the supply cable is adequate for the unit.

7.Disconnect the power before moving the unit. Move the unit with care. Excessive force or shock may damage the unit.

Do not place this camera on an unstable stand, tripod, bracket, or mount. The unit may fall, causing serious injury and/or serious damage to the unit. When a cart is used, use caution and care when moving the cart/camera combination to avoid injury from tip-over. Quick stops, excessive force, or uneven surfaces may cause the cart and/or camera to overturn. Mount the camera per the manufacturer's instructions, and only with MIC mounting accessories.

For transportation, rotate the ball so that the window points toward the base. This will protect the wiper and the windows during transit.

Bosch Security Systems, Inc. Installation Manual F.01U.249.416 2.0 2012.09