Bosch Appliances MIC612 installation manual EC Directives, Important Notices

8 en SafetyMIC612 Thermal Camera

	8.		Do not point the camera at the sun. Bosch Security Systems will not be liable for any
			damage to cameras that have been pointed directly at the sun.
	9.		Do not back drive the pan or tilt axis of the camera. Doing so will damage the motor drive
			gear chain and will invalidate the warranty.
		NOTICE!
		This device is intended for use in public areas only.
		U.S. federal law strictly prohibits surreptitious recording of oral communications.
1.5		EC Directives
		The MIC612 complies with the following EC directives:
		– EMC Direct (89/336/EC as amended)
		–	Machinery Directive (98/37/EC)
		–	LV Directive (73/23/EC)
		– RoHS (Restriction of Hazardous Substances) 2002/95/EC
		– WEEE (Waste Electrical and Electronic Equipment) 200/96/EC
		NOTICE!
		This equipment contains electrical or electronic components that must be recycled properly in
		order to comply with Directive 2002/96/EC of the European Union regarding the disposal of
		waste electrical and electronic equipment (WEEE). Contact your local supplier for procedures
		for recycling this equipment.
		Environmental statement - This symbol means that electronic and electrical appliances
		which have reached the end of their working life must be collected and disposed of separately
		from household waste material. Separate collecting systems are usually in place for electronic
		and electrical products. Please dispose of these units at an environmentally compatible
		recycling facility, per European Directive 2002/96/EC.
		Bosch has a strong commitment towards the environment. The camera was designed and
		manufactured with high-quality material and components that can be recycled and reused.
1.6		Important Notices
		Cold Start-ups- If camera is powered up in extremely cold temperature (for example, -

40°C),please allow 30 minutes warm-up after powering camera prior to operation. In some cases,camera may require soft reset (Aux ON 911) or a power cycle before usable video is available.

Ventilation - The camera is a completely sealed unit and requires no special consideration as regards to ventilation.

Object and liquid entry - With the exception of the base connector, the camera can be exposed to non corrosive liquids without damage. Never push objects into the base connector as this may damage the connection pins and prevent the camera operating correctly. Lightning - For added protection during a lightning storm, or when leaving this unit unattended and unused for long periods, unplug the unit from the wall outlet and disconnect the cable system. This will prevent damage to the unit from lightning and power line surges. Power sources - Operate the unit only from the type of power source indicated on the label. Before proceeding, disconnect the power from the cable to be installed into the camera.

– For external power supplied units, use only the recommended or approved power supplies.

– For limited power source units, this power source must comply with EN60950. Substitutions may damage the unit or cause fire or shock.

F.01U.249.416 2.0 2012.09 Installation Manual Bosch Security Systems, Inc.