Bosch Appliances MIC612 Setting Passwords, Configuring the Camera for Inverted Operation, 5.4.4

36 en Getting Started MIC612 Thermal Camera

5.Use the joystick to enter the unique identifier for the camera.

–Move the joystick up or down to select the number.

–Move the joystick right to move to the next number position.

6.Move the joystick right to select Continue. Then, press the FOCUS or the IRIS button.

7.Use the keyboard to enter the FastAddress number. Then, press the Camera button. Note: To use a FastAddress number that is already assigned to a different camera, you must clear the number first.

8.Move the joystick down then up again to set the FastAddress number.

9.Press the FOCUS or the IRIS button to store the FastAddress number.

The on-screen display menu confirms that the camera stored the FastAddress number.

5.4.4	Active Commands in FastAddress
		The table below identifies the commands that will work and those that will not when users
		send commands via the FastAddress of the thermal camera:
		Commands that will work	Commands that will not work
		Pan, tilt	Menu commands
		Thermal camera commands	Visible camera commands
		Certain Aux commands	Certain Aux commands
		(list to be populated)

5.5	Setting Passwords
	Passwords are used to control access to locked command menus. Unlocked commands are
	available to all users. Passwords are four (4) digits in length.
5.5.1	Special Passwords
	The table below identifies special passwords adn their function and security level.
	Password	Function / Security Level
	0000 (default)	Enables security and requires a user to enter the unlock command
		OFF-90-ENTERbefore invoking a locked command.
	9999	Disables all security and allows all users to access locked commands.
5.5.2	Setting Passwords, Bosch Protocol
	To set or change a password (locked command):

1.Press OFF-90-ENTERto turn off the command lock.

2.Press SET-802-ENTERto access the password menu.

3.Tilt the joystick up or down to choose a number. Tilt the joystick right to move to the next number position.

4.Follow the on-screen instructions and save the password. You receive an on-screen confirmation.

5.6 Configuring the Camera for Inverted Operation

The video display from a camera installed in inverted position will appear upside down until you set the video orientation to “Inverted position.” Follow these steps:

1.Access the main Setup Menu of the on-screen display (OSD). The screen Setup Menu appears.

2.Select the submenu “PTZ Setup.” The screen PTZ Setup appears.

3.Select the option “Orientation.”

4.Select the value “Inverted,” which rotates the video 180°. The video should now appear upright.

F.01U.249.416 2.0 2012.09 Installation Manual Bosch Security Systems, Inc.