Bosch Appliances MIC612 Recording Tours, Using the Wiper/Washer, To Record Tour A

MIC612 Thermal CameraCommon User Commands en 61

9.6 Recording Tours

The MIC612 can make up to two (2) recorded tours. A Recorded Tour saves all manual camera movements made during the recording, including its rate of pan, tilt and zoom speeds and other lens setting changes.

To Record Tour A:

1.Press ON-100-ENTERto start recording a tour.

2.Press OFF-100-ENTERto stop recording.

To playback Recorded Tour A:

1.Press ON-50-ENTERto begin continuous playback.

2.Press OFF-50-ENTERor move the joystick to stop playback.

To Record Tour B:

1.Press ON-101-ENTERto start recording the tour.

2.Press OFF-101-ENTERto stop the tour.

To playback Recorded Tour B:

1.Press ON-52-ENTERto begin continuous playback.

2.Press OFF-52-ENTERor move the joystick to stop playback.

9.7 Using the Wiper/Washer

The "predefined position" for the wash/wipe function is preset 62. The installer must define preset 62 (preferably where the washer nozzle is located and can direct washer fluid towards the camera window) before using the wiper/washer function.

To activate the washer/wiper function:

1.Press ON-105-ENTER, and then confirm this sequence:

2.The wiper moves to a predefined position.

3.The washer turns on for five seconds. Simultaneously, the wiper turns on and wipes five times.

4.The washer turns off. The wiper continues wiping for five more wipes as the camera returns to its initial PTZ position (and to inactive mode if applicable).

5.The wiper turns off.

To activate continuous wipe:

Press ON-102-ENTER. The wiper wipes continuously for up to 5 minutes, or until another OFF-102-ENTER command is sent (if the command is sent before the 5 minutes elapse).

The wiper then turns off automatically.

To activate intermittent wipe:

Press ON-103-ENTER. The wiper wipes twice, then returns to parked position, and turns off 15 seconds later. This sequence will continue for up to 5 minutes or until an OFF-103- ENTER command is sent.

To activate the wiper to wipe five (5) times:

Press ON-104-ENTER. The wiper wipes five (5) times, or until an OFF-104-ENTER command is sent (if the command is sent before the wiper wipes five (5) times), then returns to parked position and turns off.

NOTICE!

If the power fails while the wiper is activated, the wiper will return to ’parked’ position, after power is restored, before turning off. The wiper will not stop in front of the camera window.

Bosch Security Systems, Inc. Installation Manual F.01U.249.416 2.0 2012.09