18 en Connecting the Washer Pump (optional) | High Speed Pan/Tilt System |
|
|
2.Insert the cables inside the mount so they protrude approximately 0.5 m (19.7 in.).
3.Insert the cable into the cable glands and, keeping the base at about 20 cm (7.9 in.) from the support, lock the cable glands.
4.Set the base on the mount, aiding the cables to achieve the correct position inside.
5.Attach the base to the mount using the supplied screws.
6.Cut the cables to size and either restore or make the connections to the positioning unit.
7.After you have attached the base to the mount, shorten the washer pipe as required and attach it to the coupling as follows:
a.unfasten the nut from the coupling,
b.insert it into the pipe,
c.insert the end of the pipe onto the nosecap.
d.Lock the nut to the coupling (see Figure 5.2).
1 | 5 |
2 3
6 
7
4 | 8 |
9
Fig. 5.2 Installing the Washer Pipe
Reference # | Description |
|
|
1 | Washer Pipe |
|
|
2 | Nut |
|
|
3 | Nosecap |
|
|
4 | Coupling |
|
|
5 | Bracket |
|
|
6 | Noseclip |
|
|
7 | Screws |
|
|
8 | Washers |
|
|
9 | Delivery Hose |
|
|
8.Attach the pipe to the washer support using the supplied bracket, screws, and washers.
9.Lock the coupling using the supplied hoseclip and connect the delivery hose.
10.Calibrate the jet (see Figure 5.3) by directing the nozzle towards the glass of the housing.
F01U.073.990 Version 1.0 2007.07 | Instruction Manual | Bosch Security Systems |
