56 en | Configuring the System High Speed Pan/Tilt System
F01U.073.990 | Version 1.0 | 2007.07 Instruction Manual Bosch Security Systems
11.5 Creating a New Dynamic Mask
Select "Mask Changing" and an 8 x 6 grid is displayed on the screen. In the top right corner is
the Mask Number, and in the bottom left corner is the text "PTZ Mode: Masking". Then pro-
ceed as follows:
Fig. 11.27 Creating new dynamic masks
An "x" is displayed at the bottom of the parameters mode masking screen, indicating a mask
has been set.
Note: The tilt angle at which you can set the mask is between -40 to +70 degrees. It is recom-
mended that you set the mask size to larger than the object size (height and width) - this is to
ensure masking even during pan, tilt and zoom.
Press Set Shot - 1 - Enter to change
from masking mode to move camera
mode.
PTZ MODE: MASKING
Operate the joystick on the keyboard
to move the UPH and, if necessary,
operate the zoom to center the object
that will be masked. In this example,
we are going to mask a flower.
PTZ MODE: MOVE CAMERA
When the object is centered, press the
Set Shot - 2 - Enter and press Iris Open
or Close.
PTZ MODE: MOVE CAMERA
A small yellow rectangle is displayed.
Operate the joystick (left, right, up &
down) to enlarge the rectangle until it
covers the whole flower.
PTZ MODE: MASK CHANGING
When the desired result is obtained,
confirm by pressing the Iris Open or
Close button. A message indicates that
the mask has been saved.
PTZ MODE: MASKING