High Speed Pan/Tilt SystemInstalling the High Speed Pan/Tilt en 15
4.3 | Connecting the Power Supply | |
| The base with power supply box is available in two (2) power supply voltages (24 VAC or | |
| 230 VAC). Before proceeding with the installation, check the identification label of the prod- | |
| uct to verify that the device coincides with the power supply requirements. | |
|
|
|
| ! | CAUTION! |
| When connecting the base, make sure the power supply is disconnected and | |
| that the disconnecting switch is open. | |
|
|
|
When the base is opened, the power supply board appears as shown below. To connect the power supply, make the connections as seen in Figure 4.7.
Power Supply and
Fig. 4.7 Connecting the Power Supply
To wire the power cable (not supplied), use Table 4.2 to attach the appropriate colored wire to the appropriate terminal.
Wire Color | 24 VAC Terminal Connection |
|
|
Per local Installer | Neutral |
|
|
Per local Installer | Live/Active |
|
|
Green/Yellow | Earth |
|
|
Wire Color | 230 VAC Terminal Connection |
|
|
Blue | Neutral |
|
|
Brown | Live/Active |
|
|
Green/Yellow | Earth |
|
|
Table 4.2 Terminal Connections
Bosch Security Systems | Instruction Manual | F01U.073.990 Version 1.0 2007.07 |
