Bosch Appliances VIP X1600 M4S manual Assigning an IP address, Reboot

110 en Appendix VIP X1600 M4S

Assigning an IP address

To use a module in your network, you must assign it an IP address that is valid for your network.

The following default address is preset at the factory: 192.168.0.1

1.Start a terminal program such as HyperTerminal.

2.Enter the user name service. The terminal program displays the main menu.

3.Enter command 1 to open the IP menu.

4.Enter 1 again. The terminal program displays the current IP address and prompts you to enter a new IP address.

5.Enter the desired IP address and press Enter. The terminal program displays the new IP address.

6.Use the displayed commands for any additional settings you require.

i	NOTICE!
	You must reboot to activate the new IP address, a new subnet mask or a gateway IP address.

Reboot

Briefly interrupt the power supply to the VIP X1600 XF for a reboot (disconnect the power supply unit from the mains supply and switch on again after a few seconds).

Additional Parameters

You can use the terminal program to check other basic parameters and modify them where necessary. Use the on-screen commands in the various submenus to do this.

DOC V4.0 2009.06 Installation and Operating Manual Bosch Security Systems