VIP X1600 M4SConfiguration Using a Web Browser en 31
| – | Modem |
|
| For analog modem connections with 20 kbps, resolution 352 × 288/240 pixels |
| – | GSM |
|
| For GSM connections at 9,600 baud, resolution 176 × 144/120 pixels |
5.7 | Basic Mode: Audio (Audio Version Only) | |
You can set the gain of the audio signals to suit your specific requirements. The current video image is shown in the small window next to the slide controls to help you check the audio source and improve assignments. Your changes are effective immediately.
If you connect via Web browser, you must activate the audio transmission on the LIVEPAGE Functions page (see Section 5.15 Advanced Mode: LIVEPAGE Functions, page 40). For other connections, the transmission depends on the audio settings of the respective system.
Audio
The audio signals are sent in a separate data stream parallel to the video data, and so increase the network load. The audio data are encoded according to G.711 and require an additional bandwidth of approx. 80 kbps for each connection. If you do not want any audio data to be transmitted, select Off.
Line In 1 to Line In 4
You can set the gain for the line inputs. Make sure that the display does not go beyond the green zone during modulation.
5.8 | Basic Mode: Recording |
You can record the images from the camera connected to the module on an appropriately configured iSCSI system.
You can start or stop the recording immediately here.
Storage medium
1.Select the required storage medium from the list.
2.Click the Start button to start the recording immediately.
Bosch Security Systems | Installation and Operating Manual | DOC V4.0 2009.06 |
