VIP X1600 M4S | Installation en 19 |
|
|
4.3Connections
Cameras
You can connect a maximum of four video sources to the module. Any cameras and other video sources that produce a standard PAL or NTSC signal are suitable.
1.Connect the cameras or other video sources to the BNC sockets Video In 1 to Video In 4 using a video cable (75 Ohm, BNC plug).
2.If the video signal is not looped through, termination is performed by a software setting if necessary (see Section 5.17 Advanced Mode: Video Input, page 42).
Audio Connections
The audio version of the VIP X1600 M4S module has two audio line inputs for a total of four mono signals.
The audio signals are transmitted at the same time as the video signals. As a result, you can connect a speaker or door intercom system at the destination point, for example. The following specification should be complied with in all cases:
Impedance 9 kOhm typ., 5.5
The stereo plugs must be connected as follows:
Contact | Audio In 1/2 | Audio In 3/4 |
|
|
|
Tip | Channel 1 | Channel 3 |
|
|
|
Middle ring | Channel 2 | Channel 4 |
|
|
|
Lower ring | Ground | Ground |
|
|
|
Bosch Security Systems | Installation and Operating Manual | DOC V4.0 2009.06 |
