VIP X1600 M4S | Configuration Using a Web Browser en 45 |
|
|
–High resolution (4CIF/D1)
High resolution for high bandwidth connections, resolution 704 × 576/480 pixels
–DSL
For DSL connections with 500 kbps, resolution 352 × 288/240 pixels
–ISDN (2B)
For ISDN connections via two
–ISDN (1B)
For ISDN connections via one
–Modem
For analog modem connections with 20 kbps, resolution 352 × 288/240 pixels
–GSM
For GSM connections at 9,600 baud, resolution 176 × 144/120 pixels
You can choose between the code algorithms
1.Select the required profile for every data stream.
2.Select the required code algorithm for every data stream.
You can change individual parameter values of a profile and you can also change the name. You can switch between profiles by clicking the appropriate tabs.
CAUTION!
The profiles are rather complex. They include a large number of parameters that interact with
!one another, so it is generally best to use the default profiles.
Change the profiles only once you are fully familiar with all the configuration options. In the default setting, Stream 2 is transmitted for alarm connections and automatic connections. Bear this fact in mind when assigning the profile.
NOTICE!
i | All parameters combine to make up a profile and are dependent on one another. If you enter a |
| |
| setting that is outside the permitted range for a particular parameter, the nearest permitted |
| value will be substituted when the settings are saved. |
|
|
Preview for
Select which video data stream should be displayed in the previews. You can deactivate the display of the video images if the performance of the computer is affected too strongly by the decoding of the data streams.
1.Check the box for the required data stream.
2.Click the i icon above the relevant preview to display further information about the data stream.
Profile name
You can enter a new name for the profile here. The name is then displayed in the list of available profiles in the Active profile field.
Target data rate
You can limit the data rate for the module to optimize utilization of the bandwidth in your network. The target data rate should be set according to the desired picture quality for typical scenes with no excessive motion.
For complex images or frequent changes of image content due to frequent movements, this limit can be temporarily exceeded up to the value you enter in the Maximum data rate field.
Bosch Security Systems | Installation and Operating Manual | DOC V4.0 2009.06 |
