78 en Configuration Using a Web Browser | VIP X1600 M4S |
|
|
SNMP host addresses, SNMP traps are sent automatically. Select Off to deactivate the SNMP function.
1. SNMP host address / 2. SNMP host address
If you wish to send SNMP traps automatically, enter the IP addresses of one or two required target units here.
SNMP traps
You can select which traps are to be sent.
1.Click Select. A list is opened.
2.Click the checkboxes to select the required traps. All the checked traps will be sent.
3.Click Set to accept the selection.
Authentication (only for the module in Slot 1)
If a RADIUS server is employed in the network for managing access rights, authentication must be activated here to allow communication with the unit. The RADIUS server must also contain the corresponding data.
To configure the unit, you must connect the VIP X1600 XF directly to a computer using a network cable. This is because communication via the network is not enabled until the Identity and Password parameters have been set and successfully authenticated.
CAUTION!
!The switch used for the network must support the
several hosts for communicating over the network.
Identity (only for the module in Slot 1)
Enter the name that the RADIUS server is to use for identifying the VIP X1600 XF.
Password (only for the module in Slot 1)
Enter the password that is stored in the RADIUS server.
RTSP port
If necessary, select a different port for the exchange of the RTSP data from the list. The standard RTSP port is 554. Select Off to deactivate the RTSP function.
DOC V4.0 2009.06 | Installation and Operating Manual | Bosch Security Systems |
