Bosch Appliances VIP X1600 M4S manual Advanced Mode Alarm Connections, Connect on alarm

56 en Configuration Using a Web BrowserVIP X1600 M4S

5.26 Advanced Mode: Alarm Connections

You can select how the module responds to an alarm. In the event of an alarm, the unit can automatically connect to a pre-defined IP address. You can enter up to ten IP addresses which the module will select in order, until a connection is made.

Connect on alarm

Select On so that the module automatically connects to a pre-defined IP address in the event of an alarm.

By setting Follows input 1 the unit maintains the connection that has been automatically established for as long as an alarm exists on alarm input 1.

NOTICE!

i In the default setting, Stream 2 is transmitted for alarm connections. Bear this fact in mind when assigning the profile (see Section 5.19 Advanced Mode: Encoder Profile, page 44).

Number of destination IP address

Specify the numbers of the IP addresses to be contacted in the event of an alarm. The module contacts the remote stations one after the other in the numbered sequence until a connection is made.

Destination IP address

For each number, enter the corresponding IP address for the desired remote station.

Destination password

If the remote station is password protected, enter the password here.

In this page, you can save a maximum of ten destination IP addresses and hence up to ten passwords for connecting to remote stations. If connections to more than ten remote stations are to be possible, for example when initiating connections via higher-ranking systems such as VIDOS or Bosch Video Management System, you can store a general password here. The

DOC V4.0 2009.06 Installation and Operating Manual Bosch Security Systems