Brother FAX-1030Plus Remote Control Commands, Remote access command Detailed operation

REMOTE FAX OPTIONS - CHAPTER 9

Remote Control Commands

You can control your fax machine with the following remote control commands.

Remote access command			Detailed operation
95	Changing Fax Forwarding
	setting
	1	OFF	If you hear one long beep, the change is accepted. If you hear three
			short beeps, you cannot change it because the conditions (ex. registering
	2	Fax forwarding
			fax forwarding) have not been completed. You can register your fax
	4	FAX FWD No.	forwarding number by using 4. FAX FWD NO. Once you have
	5	FWD NO. CONFIRM	registered the number, the machine will automatically turn to “FAX
			FWD:ON” mode. Then, receive a Memory Status List by entering 961.
			Check the List to make sure the Fax Forwarding number you registered
			is correct. Then enter the confirmation command 955. Now the machine
			will start Fax Forwarding.
	6	FAX STORAGE ON	You can set FAX STORAGE ON or OFF.
	7	FAX STORAGE OFF
96	Retrieve FAX
	1	Memory Status List	You must use a remote fax machine in order to receive a List or stored
			fax message(s).
	2	00 Retrieve all FAX
	2	“MSG No.” 00
		Retrieve by MSG
		number
	3	Erase FAX in the	If you hear one long beep, you can erase fax message(s) from the
		memory	memory.
97 Check the receiving status			You can check whether your fax machine has received any fax
			message(s). If yes, you will hear one long beep. If no, you will hear
	1	DOC
			three short beeps.
98	Change Answer Mode		If you hear one long beep, you can change the answer mode. If you
			hear three short beeps, you cannot change it.
	1	TAD
	2	F/T
	3	FAX
90	Exit		After a long beep, you can exit remote control.

9-6