Brother FAX-1030Plus, Fax-1020Plus owner manual 10-26

MESSAGE MANAGER MODE SETTINGS (Only for FAX 1030 Plus)

Remote Control Commands

You can control your fax machine by remote control command.

		Remote control command						Detail Operation
91			Playing voice messages					After one long beep, the machine plays ICM, Memo and Memo Manager.
			1	Z (Skip back)				Press 1 while listening to an ICM, Memo or Memo Manager message to play it
								again. If you press 1 before a message, you will hear the previous message.
			2	X (Skip next)				During playing ICM, Memo and Memo Manager, you can skip to next message.
			9	Stop Playing				Stop playing ICM, Memo and Memo Manager.
92			Record Memo					After one long beep, you can record a memo. You can stop recording by pressing
						9.
93			Erase all ICM & Memo					If you hear one long beep, the erase is accepted. If you hear three short beeps,
								you cannot erase because all voice messages have not been played, or there is
								no voice message to erase.
								*This code erases all recorded messages, not one by one.
94			Play and Record OGM
			in memory
	1	Play			1 TAD MSG			The machine plays the selected OGM. You can stop playing OGM by pressing
							9.
					2 F/T MSG
					3 PAGING MSG
	2	Record			1 TAD MSG			After one long beep, you can record the selected OGM. You will hear the OGM
								message played once. You can stop recording the message by pressing 9.
					2 F/T MSG
					3 PAGING MSG
95			Changing Fax Forwarding					If you hear one long beep, the change is accepted. If you hear three short beeps,
			/Paging setting					you cannot change it because the conditions (ex. registering paging number)
								has not been completed. You can register your fax forwarding number by using
			1	OFF
								4. FAX FWD No.. Once you have registered the number, the machine will
			2	Fax Forwarding				automatically turn to “FAX FWD:ON” mode. Then receive a Memory Status
								List by entering 961. After you make sure that the Fax Forwarding number you
			3	Paging				registered is correct in the List, enter the confirmation command 955. Now the
								machine will start Fax Forwarding.
			4	FAX FWD No.
			5	FWD No. Confirm
96			Retrieve FAX
			1	Memory Status List				You must call from a remote fax machine in order to receive a report or stored
								fax messages.
			2	00	Retrieve all FAX
			2	“MSG No.” 00
					Retrieve by MSG
					number
			3	Erase FAX in the				If you hear one long beep, you can erase fax message in the memory.
				memory
97			Check the receiving status					You can check whether your fax machine has received any DOCUMENT or
								VOICE messages. If yes, you will hear one long beep. If no, you will hear three
			1	DOC
								short beeps.
			2	VOICE
98			Change Answer Mode					If you hear one long beep, you can change it. If you hear three short beeps, you
								cannot change it. (ex. There is no TAD MSG when you want to change to TAD
			1	TAD
								mode.)
			2	F/T
			3	FAX
90			Exit					After a long beep, you can exit remote control.

10-26