Brother ULT2002D operation manual When Sewing Straight Stitches only

5	5
	1 3
2	2
A	B
	3
	5

8.Place the fabric as shown left figure B.

-Right side of cut: on top of the guide plate

-Left side of cut: underneath the presser foot

1 Guide plate (lower knife)

2 Presser foot

9.Thread the needle, then pull out a long section of the upper thread, pass it below the presser foot and pull it out in the fabric feed direction (see left figure B).

2 Presser foot

3 Upper thread

10.Lower the presser foot lever.

CAUTION

If the width has been adjusted, turn the balance wheel by hand to check that the needle does not touch the side cutter. If the needle touches the side cutter, it may cause the needle to break.

CONTENTS

1 —

2 —

3 —

4 —

5 —

	When Sewing Straight Stitches only
1	The seam margin should be about 5 mm (3/16 inch).
	1 Seam margin

*Make sure you select a pattern for the side cutter.

*Clean the side cutter after use, to avoid having dust and scraps of thread build up on it.

*Add a small amount of oil as required to the cutting edge of the cutter.

Note

•The fabric will not be cut if the whole fabric is simply spread out underneath the presser foot guide plate. Set

the fabric as explained in step 8, and then start sewing.

• Check that the needle is raised when the presser foot lever is raised.

• One layer of 13 oz. denim can be cut.

6 —

7 —

8 —

9 —

?!

Sewing Utility Stitches

3-27

Index