Brother ULT2002D operation manual Chine

5

		CONTENTS
7.	Press the “Start/Stop” button to begin sewing.
		1 —
*	Guide the fabric lightly by hand.

6

8. Press the “Start/Stop” button again to stop sewing.

2 —

3 —

4 —

5 —

9. Press the “Thread Cutter” button to trim the threads. * The needle will return to the up position automatically.

CAUTION	6 —
Do not press the “Thread Cutter” button after the
threads have been cut. Doing so could tangle the
thread or break the needle and damage the ma-
chine.	7 —

CAUTION

•Do not press the “Thread Cutter” button when there is no fabric set in the machine or during machine op- eration. The thread may tangle, resulting in damage. 8 —

• When cutting thread thicker than #30, nylon thread, or other decorative threads, use the thread cutter on the side of the machine.

9 —

?!

10.When the needle has stopped moving, raise the presser foot and remove the fabric.

Note

This machine has a display to warn you when the bobbin thread has run out. If the warning displays, re-thread the machine immediately.

2-2 Getting Ready to Sew

Index