Brother ULT2002D operation manual Etc Fabric was not inserted into the frame

Problem	Cause	Solution	Page
	1 Thread is twisted.	Use scissors, etc., to cut the twisted	7-2
		thread and remove it from the race,
		etc.
	2 Fabric was not inserted into the frame	If the fabric is not stretched tight in	5-21
	correctly ( fabric was loose, etc.).	the frame, the pattern may turn out
		poorly or there may be shrinkage
		of the pattern. Set the fabric into
		the frame correctly.
	3 Stabilizing material was not attached.	Always use stabilizing material, especially	5-20
		with stretch fabrics, lightweight fabrics,
		fabrics with a coarse weave, or fabrics that
		often cause pattern shrinkage. See your
		authorized dealer for the proper stabilizer.
	4 There was an object placed near the	If the frame bumps something dur-	5-29
	machine, and the carriage or embroi-	ing sewing, the pattern will turn out
	dery frame hit the object during sew-	poorly. Do not place anything in
Embroidery	ing.	the area where the frame may
		bump it during sewing.
pattern
	5 Fabric outside the frame edges inter-	Reinsert the fabric in the embroi-	5-46
does not
sew out	feres with the sewing arm, so the em-	dery frame so that the excess fab-
	broidery unit can not move.	ric is away from the sewing arm,
correctly
		and rotate the pattern 180 degrees.
	6 Fabric is too heavy, so the embroidery	Place a large thick book or similar	—
	unit can not move freely.	object under the arm head to lightly
		lift the heavy side and keep it level.
	7 Fabric is hanging off the table.	If the fabric is hanging off the table	5-29
		during embroidery, the embroidery
		unit will not move freely. Place the
		fabric so that it does not hang off
		the table (or, hold fabric to keep
		from dragging).
	8 Fabric is snagged or caught on some-	Stop the machine and place the	—
	thing.	fabric so that it does not get caught
		or snagged.
	9 Embroidery frame was removed during	If the presser foot is bumped or the	5-35
	sewing (for example, to reset the bob-	embroidery unit is moved during
	bin). The presser foot was bumped or	sewing, the pattern will not turn
	moved while removing or attaching the	out. Be careful when removing or
	embroidery frame, or the embroidery	reattaching the embroidery frame
	unit was moved.	during sewing.

CONTENTS

1—

2—

3—

4—

5—

6—

7—

8—

9—

?!

Troubleshooting

9-7

Index