Brother ULT2002D operation manual When sewing with fine, cross-wound thread see the il

3.Pivot the spool pin so that it angles toward the front of the machine. Set the thread spool on the spool pin so that the thread unrolls from the front of the spool.

4.Push the spool cap onto the spool pin as far as possi- ble, then return the spool pin to its original position.

1 1 Spool cap

CAUTION

•If the thread spool and/or spool cap are set incorrectly, the thread may tangle on the spool pin and cause the needle to break.

•Use the spool cap (large, medium, or small) that is closest in size to the thread spool. If a spool cap smaller than the thread spool is used, the thread may become caught in the slit on the end of the spool and cause the needle to break.

3		Note
	2	When sewing with fine, cross-wound thread (see the il-
		lustration), use the small spool cap, and leave a small space
		between the cap and the thread spool (see the illustration
		at left).
		1 Spool cap (small)
1		2 Thread spool (cross-wound thread)
		3 Space
	1	5. Hold the thread from the spool in both hands, and pass
		the thread around the plate in the thread guides. Use
		both hands to set the thread around the thread guide
		plate.
2		1 Thread guide plate
	1
	▼
	3
2
1
		Setting Up	1-33

CONTENTS

1—

2—

3—

4—

5—

6—

7—

8—

9—

?!

Index