Brother ULT2002D operation manual Setting the Bobbin

Setting the Bobbin

Press ➜ ➜ ➜ in that order to display a video example of the

operation on the LCD (see page 1-21).Follow the steps explained below to complete the operation.

CAUTION

Setting the bobbin improperly may cause the thread tension to loosen, breaking the needle and resulting in injury.

1 Wound evenly
2 Wound poorly	1	2

CONTENTS

1 —

2 —

3 —

1

1.Raise the presser foot lever.

2.Slide the bobbin cover latch to the right, and remove the bobbin cover.

1 Bobbin cover

3.Put the bobbin in the shuttle, making sure the thread unrolls as shown.

CAUTION

Be sure the bobbin is set so the thread unrolls in the correct direction. If the thread unrolls in the wrong direction, it may cause the thread tension to be incorrect or the needle to break.

4 —

5 —

6 —

7 —

1

4.Guide the thread through the groove, then pull the thread toward you to cut off any excess.

1 Cutter

5.Replace the bobbin cover. Place the left tab in place (see arrow 1 at left), then press lightly on the right side (see arrow 2 at left) until the cover clicks into place.

Note

You can begin sewing without pulling up the bobbin thread.

When you need to pull up the bobbin thread (free motion embroidery) see the illustrated directions on page 1-38.

8 —

9 —

?!

Setting Up 1-31

Index