Brother ULT2002D operation manual Error Messages, Is touched

ERROR MESSAGES

CONTENTS

If the machine is not properly set and the “Start/Stop” button or the “Reverse/Reinforcement Stitch” button is pressed, or if the operation procedure is incorrect, the machine does not start. An alarm sounds and an error message is displayed on the LCD. If an error message displays, follow the instructions in the message.

Below is an explanation of 49 error messages. Refer to these when necessary (if you press or do the operation correctly while the error message is displayed, the message disappears).

1—

2—

1.

This message is dis- played when the motor locks due to tangled thread or for other reasons relate to thread delivery.

2.

This message is dis- played when the presser foot is raised and the “Start/Stop” button, “Reverse/Reinforcement Stitch” button, or “Thread Cutter” button pushed.

3.

This message is dis- played when the upper thread is broken or not threaded correctly, and the “Start/Stop” button or the “Reverse/ Reinforcement Stitch” button is pressed.

CAUTION

Be sure to rethread the machine. If you press the “Start/Stop” button without rethreading the machine, the thread tension may be wrong or the needle may break and cause injury.

4.

This message is dis- played when the

is touched

without an embroidery card inserted.

5.

This message is dis- played when the embroidery unit initialization is started with the presser foot lever down.

6.

This message is dis-

played if the is

touched when an unusable embroidery card is inserted.

3—

4—

5—

6—

7—

8—

9—

?!

9-10 Troubleshooting

Index