Brother ULT2002D operation manual Bobbin Winding/Lower Threading

Bobbin Winding/Lower Threading

Press ➜ ➜ ➜ in that order to display a video example of bobbin

winding on the LCD (see page 1-21).Follow the steps explained below to complete the operation.

CONTENTS

1 —

CAUTION

Use only bobbins recommended by the manufacturer of this machine (see page 1-8).Using other bobbins may result in damage or injury.

				7
		6		2
			8		l
				9,10	o
5	4	3			1
		11
	1		1. Turn on the main power switch.
			2. Align the groove in the bobbin with the spring on the
	2		bobbin winder shaft, and set the bobbin on the shaft.
			1 Groove of the bobbin
			2 Spring on the shaft
			3. Pivot the spool pin so that it angles toward the front of
			the machine. Set the thread spool on the spool pin so
			that the thread unrolls from the front of the spool.
	1		4. Push the spool cap on the spool pin as far as possible,
			then return the spool pin to its original position.
			1 Spool pin
2			2 Spool cap
			3 Thread spool
3

CAUTION

•If the thread spool and/or spool cap are set incorrectly, the thread may tangle on the spool pin and cause the needle to break.

•Use the spool cap (large, medium, or small) that is closest in size to the thread spool. If a spool cap smaller than the thread spool is used, the thread may become caught in the slit on the edge the spool and cause the needle to break.

Setting Up 1-25

2—

3—

4—

5—

6—

7—

8—

9—

?!

Index