Brother ULT2002D operation manual There is no pattern selected Select a pattern

Problem	Cause	Solution	Page
	1 There is no pattern selected.	Select a pattern.	3-9,4-1
			5-8,6-2
	2 “Start/Stop” button was not pushed.	Push the “Start/Stop” button.	1-3
	3 Main power switch is not turned on.	Turn on the main power switch.	1-12
Machine	4 Presser foot is not lowered.	Lower the presser foot.	1-4
	5 “Start/Stop” button was pushed with the	Remove the foot controller, or use	1-7
does not	foot controller attached.	the foot controller to operate the
operate
		machine.
	6 Using the foot controller for embroi-	Remove the foot controller and use	1-7
	dery.	the “Start/Stop” button to operate
		the machine.
	7 Speed control lever is set to control the	Use the foot controller instead of	1-7
	zigzag stitch width.	the “Start/Stop” button to operate
		the machine.
Embroidery	1 There is no pattern selected.	Select a pattern.	5-8,6-2
	2 Main power switch is not turned on.	Turn on the main power switch.	1-12
unit does
	3 Embroidery unit is not attached cor-	Reattach the embroidery unit cor-	5-5
not operate	rectly.	rectly.
	4 Embroidery frame was attached before	Perform the initialization process	5-5
	the unit was initialized.	correctly.
LCD	1 LCD contrast is not properly adjusted.	Adjust the LCD contrast.	1-16,
display is			8-1
difficult to
see

CAUTION

•This machine is equipped with a thread detection device. If the “Start/Stop” button is pushed before the upper threading is done, the machine will not operate properly. Also, depending on the pattern selected, the machine may feed the fabric even if the needle is raised. This is due to the needle bar release mechanism. At these times, the machine will make a sound different from that made during normal sewing. This is not the sign of a malfunction.

•If the power is disconnected during sewing:

-Turn off the main power switch and unplug the machine.

-If you restart the machine, follow the instructions for operating the machine correctly.

CONTENTS

1—

2—

3—

4—

5—

6—

7—

8—

9—

?!

Troubleshooting

9-9

Index