Details of each item are shown below.

[RX Start]:

This key is used only for receiving data from a fax

 

information service. It is not used when sending. (See

 

"Fax Information Services," on p. 3-41.)

[Tone]:

Press when you want to directly call an extension line

 

that is connected to a PBX (Private Branch Exchange),

 

which accepts only tone signals. If you press [Tone], the

 

letter <T> appears. (See "Fax Information Services," on

 

p. 3-41.)

< > or < >:

Press [▼] (reduce) or [▲] (increase) to adjust the

 

volume of the dial tone.

[One-touch Dialing]:

Press to specify destinations using the one-touch

 

buttons. (See "Address Book," on p. 2-19.)

NOTE

•You can change settings for Resolution, Density, and Image Quality before you start sending. (See "Resolution, Density, and Image Quality," on p. 2-2).

•To cancel Manual Sending, press [End].

5 When you hear the other party or carrier signal (a high-pitched tone), press (Start).

Scanning starts and the document is sent.

During the transmission, the transaction number, destination's telephone number, and page number are displayed in the Job Monitor area.

2

Basic Send and Receive Methods

Sending Methods

2-13