Canon W2200 manual Printing Halts During Print Job, Blank paper ejected from the printer

Printing Halts During Print Job

Error message is displayed.

Problem 1: An error message is displayed during printing.

Solution: Check if the error message appears in GARO Status Monitor for Windows or GARO Printmonitor for Macintosh and follow the instructions in the message to solve the problem. (ÆP.7-16)

Problem 2: The selected Media Size is not correct for the media loaded in the paper supply source.

Solution: Confirm the current selection for the Media Size. If the setting is not correct, stop the print job, select the correct setting, then start the print job again. (ÆP.2-8)

Problem 3: Bi-directional communication between the printer and computer cannot

execute when the printer is connected via the parallel port.

Solution: Open the Setup Menu on the printer operation panel, select “Set Centronics” Interactive then select “None”. (ÆP.5-13)

Blank paper ejected from the printer.

Problem 1: A blank page is ejected from the previous print job.

Solution: The print job starts after the blank page is ejected.

Problem 2: Printhead nozzles are clogged.

Solution: Print a nozzle check pattern, check the condition of the printhead nozzles, If you determine that the printhead nozzles are clogged, clean the printhead. (ÆP.7-28)

Problem 3: Printer is damaged.

Solution: Call for service.

Problem 4: Ink filling is not completed.

Solution: If you don’t see any ink in the ink hose, check the ink left in the ink tanks to make sure that more than 40% of the ink is left, and then perform Head Cleaning C. (ÆP.7-28) When there is little ink remaining, replace the ink tank with a new tank, and then perform printhead cleaning. (ÆP.6-2)

7-8

Troubleshooting