Cisco Systems NAM, 5 manual Vlan and IP, List is also shown in Figure

Chapter 4 Capturing and Decoding Packet Data

Sessions

The list is also shown in Figure 4-5.

Figure 4-5 Hardware Filter Type

Step 5 Data fields will then appear that correspond with the type of hardware filter you selected. Fill in the desired fields. See the following sections for more specific information.

Step 6 Click Submit to complete the configuration of the capture session. Otherwise, click Reset to revert to the previous settings, or click Cancel to abort.

VLAN

To configure a VLAN hardware filter:

Step 1 Enter a Filter Name.

Step 2 From the Type drop-down menu, choose VLAN.

Step 3 Choose either the Range or Individuals radio button. For Range, enter a range of VLANs. For Individuals, enter up to four individual VLANs.

Step 4 Click the Submit button.

VLAN and IP

To configure a VLAN and IP hardware filter:

Step 1 Enter a Filter Name.

Step 2 From the Type drop-down menu, choose VLAN and IP.

Step 3 Enter the ID of the desired VLAN. The VLAN ID can range from 1-4095.

Step 4 Enter a Source Address / Mask (optional).

Step 5 Enter a Destination Address / Mask (optional).

Step 6 Choose a Layer 4 Protocol (optional).

	User Guide for the Cisco Network Analysis Module (NAM) Traffic Analyzer, 5.0
OL-22617-01		4-13