Cisco Systems NAM, 5 Setting RTP Stream Thresholds, Give the RTP Streams Alarm Threshold a name

Chapter 2 Setting Up The NAM Traffic Analyzer

Alarms

Note If you leave a selection blank, it means that that parameter will not be considered. If you select “Any”, it will use any of the selections for that parameter, if encountered.

Step 4 Click Submit to set the thresholds, click Reset to reset the thresholds to their default value, or click Cancel to remove any changes you might have made.

Step 5 When finished, click Submit.

Setting RTP Stream Thresholds

Step 1 Choose Setup > Alarms > Thresholds.

Step 2 Click the Create button and choose the RTP Streams tab.

Step 3 The RTP Stream Alarm Threshold Configuration window displays. Fill in the fields as appropriate. Table 2-20, RTP Streams Thresholds describes the fields available on this screen.

Table 2-20 RTP Streams Thresholds

Field	Description
Name	Give the RTP Streams Alarm Threshold a name.
Severity	Choose High or Low. These will display on the Alarm Summary dashboard
	(Monitor > Overview >Alarm Summary), where you can choose to view
	High, Low, or High and Low alarms.
Codec	Choose a Codec from the list.
Source Site/Host	Make a selection from the drop-down lists, or leave as “Any.” See Sites,
	page 2-58for information on setting up a site.
Severity	Choose High or Low. These will display on the Alarm Summary dashboard
	(Monitor > Overview >Alarm Summary), where you can choose to view
	High, Low, or High and Low alarms.
Actions	From the drop-down lists, choose a Rising action and a Falling action
	(optional). See Alarm Actions, page 2-36for information on setting up
	alarm actions.

	User Guide for the Cisco Network Analysis Module (NAM) Traffic Analyzer, 5.0
OL-22617-01		2-45