2-57
User Guide for the Cisco Network Analysis Module (NAM) Traffic Analyzer, 5.0
OL-22617-01
Chapter 2 Setting Up The NAM Traffic Analyzer
Managed Device
Step 2 Click the Test Connectivity button to perform an SNMP test. Click Close when finished.
Step 3 Click Submit to submit the information and close the window.
NBAR Protocol Discovery
Note NBAR is supported on ISR routers and switches with the Catalyst 6500 Supervisor Engine 32
Programmable Intelligent Services Accelerator (PISA) running IOS 12.2(18)ZY (or later).
To set up NBAR Protocol Discovery, choose Setup > Managed Device > NBAR Protocol Discovery.
From the NBAR Protocol Discovery window, you can view the NBAR Status information and enable or
disable NBAR on all interfaces.
You must enable the NBAR Interfaces feature for the NAM to provide information about ethernet ports.
Note If your switch does not support NBAR, a message displays indicating that NBAR is not supported on
your switch.
Verify String Verify the SNMP .
Enable SNMP V3 Check the check box to enable SNMP Version 3 (with NAM 5.0, you
have the ability to manage devices with SNMPv3). If SNMPv3 is not
enabled, the community string is used.
Mode: No Auth, No Priv SNMP will be used in a mode with no authentication and no privacy.
Mode: Auth, No Priv SNMP will be used in a mode with authentication, but no privacy.
Mode: Auth and Priv SNMP will be used in a mode with both authentication and privacy.
User Name Enter a username, which will match the username configured on the
device.
Auth Password Enter the authentication password associated with the username that
was configured on the device. Verify the password.
Auth Algorithm Choose the authentication standard which is configured on the device
(MD5 or SHA-1).
Privacy Password Enter the privacy password, which is configured on the device. Verify
the password.
Privacy Algorithm Enter the privacy algorithm, which is configured on the device (AES
or DES).
Table 2-25 Router/Managed Device System Information (continued)
Field Description