Cisco Systems 5, NAM manual Security Level

Chapter 2 Setting Up The NAM Traffic Analyzer

Traffic

V3	SECURITY LEVEL		: No authentication, no privacy
V3	AUTHENTICATION		: MD5
V3	AUTH	PASSPHRASE	:
V3	PRIVACY		: DES
V3	PRIV	PASSPHRASE	:

root@172-20-104-107.cisco.com(sub-device-netflow)#

Step 6 Type exit to come out of the subcommand mode and create the device. Remember the ID value that was assigned to the new device, you will need it to create the data source!

root@172-20-104-107.cisco.com(sub-device-netflow)# exit Device created successfully, ID = 1 root@172-20-104-107.cisco.com#

Step 7 Enter the command data-source netflow. You will now be in netflow data source subcommand mode as shown here:

root@172-20-104-107.cisco.com# data-source netflow

Entering into subcommand mode for this command.

Type 'exit' to apply changes and come out of this mode.

Type 'cancel' to discard changes and come out of this mode.

root@172-20-104-107.cisco.com(sub-data-source-netflow)#

Step 8 Enter ? to see all the command options available, as in the example below:

root@172-20-104-107.cisco.com(sub-data-source-netflow)# ?

?	- display help
cancel	- discard changes and exit from subcommand mode
device-id	- netflow device ID (*)
engine-id	- netflow Engine ID
exit	- create data-source and exit from sub-command mode
help	- display help
name	- data-source name (*)
show	- show current config that will be applied on exit

(*)- denotes a mandatory field for this configuration.

root@172-20-104-107.cisco.com(sub-data-source-netflow)#

Step 9 Enter the device ID from Step 4 (required): root@172-20-104-107.cisco.com(sub-data-source-netflow)# device-id 1

Step 10 Enter the name you would like for the data source (required): root@172-20-104-107.cisco.com(sub-data-source-netflow)# name MyFirstNdeDataSource

Step 11 If desired, supply the specific Engine ID for this NDE data source (optional): root@172-20-104-107.cisco.com(sub-data-source-netflow)# engine-id 123

Step 12 Type show to look at the data source configuration that will be applied and verify that it is correct:

root@172-20-104-107.cisco.com(sub-data-source-netflow)# show

DATA	SOURCE NAME : MyFirstNdeDataSource
DATA	SOURCE TYPE : NDE (Netflow Data Export)
DEVICE ID			: 1
DEVICE		ADDRESS	: 192.168.0.1
ENGINE		ID	: 123

root@172-20-104-107.cisco.com(sub-data-source-netflow)#

	User Guide for the Cisco Network Analysis Module (NAM) Traffic Analyzer, 5.0
2-26	OL-22617-01