Cisco Systems 5 manual Cisco Waas NAM Virtual Service Blade

Chapter 1 Overview

Configuration Overview

Cisco WAAS NAM Virtual Service Blade

To set up the NAM Traffic Analyzer, Release 5.0 on a Cisco WAAS NAM Virtual Service Blade, you need to follow these steps:

Step 1 Confirm that you have completed the steps in Chapter 4, “Configuring NAM-WAAS Integration” of the Cisco WAAS NAM Virtual Service Blade Installation and Configuration Guide, specifically for “Configuring WAAS to Send Flow Information to NAM VSB” and “Configuring WAAS Data Source in NAM.”

Step 2 Configure a site for the Client network. See Sites, page 2-58.

Step 3 Configure another site for the Server network. See Sites, page 2-58.

Step 4 Choose Setup > Monitoring > WAAS Servers and click the Add button to add WAAS servers.

Step 5 Add a specific host IP address of the server that you want to monitor. If there are multiple IP addresses, you can paste them in.

Step 6 To verify that you have set up the WAAS-NAM propertly, choose Analyze > WAN Optimization > Application Performance Analysis and make sure you can see data (passthrough traffic). If you have not properly configured the Client Site and the Server Site, you will not see data in the charts.

	User Guide for the Cisco Network Analysis Module (NAM) Traffic Analyzer, 5.0
1-20	OL-22617-01