2-56
User Guide for the Cisco Network Analysis Module (NAM) Traffic Analyzer, 5.0
OL-22617-01
Chapter 2 Setting Up The NAM Traffic Analyzer
Managed Device
Note For the WS-SVC-NAM-1 and WS-SVC-NAM-2 platforms, SNMPv3 is not required. SNMP
requests and responses are communicated over an internal interface within the chassis, and
SNMPv3 is not used.
This section describes how to set router/managed device parameters.
Note This section applies only to NME-NAM devices (branch routers) and Cisco 2200 Series Appliances.
Step 1 Choose Setup > Managed Device > Device Information.
The Router System Information displays as shown in Table 2-25, R outer/Managed Device System
Information.
Contact Contact name of the network administrator for the switch.
SNMP read from switch SNMP read test result.
SNMP write to switch SNMP write test result.
Mini-RMON on switch For Cisco IOS devices, displays the status if there are any ports with
Mini-RMON configured (Available) or not (Unavailable).
NBAR on switch Displays if NBAR is available on the switch.
VLAN Traffic Statistics on Switch Displays if VLAN data is Available or Unavailable.
Note Catalyst 6500 Series switches require a Supervisor 2 or MSFC2
card.
NetFlow Status For Catalyst 6500 Series devices running Cisco IOS, if NetFlow is
configured on the switch, Remote export to NAM <address> on port
<number> displays, otherwise the status will display Configuration
unknown.
Table 2-24 Switch Information (continued)
Field Description
Tab l e 2-25 Router/Managed Device System Information
Field Description
Name Name of the router.
Hardware Hardware description of the router.
Managed Device Software
Version
Current software version of the router.
Managed Device System
Uptime
Total time the switch has been running.
Location Physical location of the router.
Contact Name of the network administrator for the router.
Managed Device IP address of the router.
SNMP v1/v2c RW Community
String
Name of the SNMP read-write community string configured on the
router