Cisco Systems 5, NAM manual IP and TCP/UDP, IP and Payload Data

Chapter 4 Capturing and Decoding Packet Data

Sessions

Step 7 Click Submit.

IP

To configure an IP hardware filter:

Step 1 Enter a Filter Name.

Step 2 From the Type drop-down menu, choose IP.

Step 3 Enter a Source Address / Mask (optional).

Step 4 Enter a Destination Address / Mask (optional).

Step 5 Choose a Layer 4 IP Protocol (optional)

Step 6 Click Submit.

IP and TCP/UDP

To configure an IP and TCP/UDP hardware filter:

Step 1 Enter a Filter Name.

Step 2 From the Type drop-down menu, choose IP and TCP/UDP

Step 3 Enter a Source Address / Mask (optional).

Step 4 Enter a Destination Address / Mask (optional).

Step 5 Choose an IP Protocol, either TCP or UDP.

Step 6 Enter a TCP/UDP Source Port (optional).

Step 7 Enter a TCP/UDP Destination Port (optional).

Step 8 Click Submit.

IP and Payload Data

To configure an IP and Payload Data hardware filter:

Step 1 Enter a Filter Name.

Step 2 From the Type drop-down menu, choose IP and Payload Data.

Step 3 Enter a Source Address / Mask (optional).

Step 4 Enter a Destination Address / Mask (optional).

Step 5 Choose an IP Protocol, either TCP or UDP.

Step 6 Enter the values for Payload Data:

•Enter an Offset from 1-1023. The offset is relative to the beginning of the payload (Layer 5).

•Enter a Value of up to four bytes (eight hex characters).

	User Guide for the Cisco Network Analysis Module (NAM) Traffic Analyzer, 5.0
4-14	OL-22617-01