Cisco Systems 7600 manual Product Number Description

Chapter 2 Route Switch Processors and Supervisor Engines

Overview

Table 2-1lists the RSP and supervisor engine configurations supported on Cisco 7600 series routers. Specific combinations of processors and modules may not be supported in your chassis. See the release notes for your software version for information about supported combinations.

Table 2-1 Route Switch Processor and Supervisor Engine Configurations

Product Number	Description
Route Switch Processor 720
RSP720-3C-10GE	• Two 10 Gigabit Ethernet (10GE) uplink ports support 10-Gbps X2
	modules
	• Three Gigabit Ethernet (1GE) uplink ports: two ports support
	1-Gbps small form-factor pluggable (SFP) module; one port
	supports 10/100/1000-Mbps RJ-45 connector
	Note Use Category 5 Shielded Twisted Pair cable at the port that
	supports the10/100/1000-Mbps RJ-45 connector.
	• Integrated 720-Gbps switch fabric
	• PFC3C and MSFC4 with 512-MB bootflash, 4-MB NVRAM,
	4-MB ROMmon, and several DRAM options:
	– Route processor (RP): 1- to 4-GB DRAM (default 1 GB)
	– Switch processor (SP): 1- to 2-GB DRAM (default 1 GB)
	• One CompactFlash Type II slot (512 KB) on front panel and two
	internal CompactFlash (512 KB each for RP and SP; you can
	optionally increase each internal CompactFlash to 1 GB)
	• Requires larger power supplies and a high-speed fan tray
	• QoS port architecture, 10GE ports (Rx/Tx): 8q8t/1p7q8t (CoS)
	• QoS port architecture, 1GE ports (Rx/Tx): 2q8t/1p3q8t
RSP720-3CXL-10GE	• Two 10GE) uplink ports support 10-Gbps X2 modules
	• Three 1GE)uplink ports: two ports support 1-Gbps small
	form-factor pluggable (SFP) module; one port supports
	10/100/1000-Mbps RJ-45 connector
	Note Use Category 5 Shielded Twisted Pair cable at the port that
	supports the10/100/1000-Mbps RJ-45 connector.
	• Integrated 720-Gbps switch fabric
	• PFC3CXL (high-capacity) and MSFC4 with 512-MB bootflash,
	4-MB NVRAM, 4-MB ROMmon, and several DRAM options:
	– Route processor (RP): 1- to 4-GB DRAM (default 2 GB)
	– Switch processor (SP): 1- to 2-GB DRAM (default 1 GB)
	• One CompactFlash Type II slot (512 KB) on front panel and two
	internal CompactFlash (512 KB each for RP and SP; you can
	optionally increase each internal CompactFlash to 1 GB)
	• Requires larger power supplies and a high-speed fan tray
	• QoS port architecture, 10GE ports (Rx/Tx): 8q8t/1p7q8t (CoS)
	• QoS port architecture, 1GE ports (Rx/Tx): 2q8t/1p3q8t

Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide

OL-10100-04 2-3