Chapter 2 Route Switch Processors and Supervisor Engines
RSP720 with 10GE Uplink Ports
RSP720 with 10GE Uplink Ports
Cisco IOS Release 12.2SRC introduces a new RSP720 with 10 Gigabit Ethernet (GE) uplink ports (RSP720-10GE). The Cisco 7600 RSP720-10GE consists of a full-size board and two integrated daughter cards: an MSFC4 and a PFC. The RSP720-10GE has an integrated switch fabric that interconnects all of the line cards in the router with point-to-point 20-Gbps full-duplex serial channels.
Two versions of the RSP720-10GE module are available:
•RSP720-3C-10GE
•RSP720-3CXL-10GE
Because of physical differences between the RSP720 and RSP720-10GE (such as the CPU memory map and ASIC operation), there are several configuration guidelines and restrictions you should be aware of. See the “RSP720-10GE Usage Guidelines and Limitations” section on page 2-10for details.
Following are the total power requirements for the RSP720-10GE:
•RSP720-3C-10GE = 355 watts (total power)
•RSP720-3CXL-10GE = 378 watts (total power)
Figure 2-2shows the RSP720-3C-10GE front panel. The RSP720-3CXL-10GE front panel is similar. See Table 2-2and Table 2-3for information about the front-panel controls and LEDs.
Figure 2-2 RSP720-3C-10GE Front Panel
| 1-GE uplink | 10-GE uplink |
Disk LEDs | ports | | CONSOLE | ports |
| | | port | |
| | | | |
RSP720-3C-10GE | | | | | |
| DISK 0 | UPLINK | | | 10GE UPLINK |
| | | 4 |
EJECT | | | 10/100/100 | 5 |
| | SFP | 3 | | |
| 1 | 3 | | | |
STATUS SYSTEM ACTIVE PWR MGMT | | | | | |
| RESET | | | | |
RSP720 WITH INTERATED SWITCH FABRIC/PFC3C-10GE | | | | CONSOLE | |
| LINK | LINK | LINK | LINK | LINK |
STATUS | | | | |
LEDs CompactFlash | LINK | 10/100/1000 | LINK |
Type II slots | LEDs | uplink port | LEDs |
250253
Note Use Category 5 Shielded Twisted Pair cable at the port that supports the10/100/1000-Mbps RJ-45 connector.
RSP720-10GE Features
The RSP720-10GE provides all of the features of the RSP720 and also provides the following benefits:
•The RSP720-10GE has two 10GE uplink ports and three 1GE uplink ports. You can use the 10GE ports as high-bandwidth uplinks and save chassis slots for high-density interfaces, such as a SIP/SPA. This is especially useful in smaller chassis and in redundant configurations. For the three 1GE uplink ports, two ports support 1-Gbps SFP modules and one port supports a 10/100/1000-Mbps RJ-45 connector.
Note Use CAT5 Shielded Twisted Pair cable at the port that supports the10/100/1000-Mbps RJ-45 connector.
•The RSP720-10GE supports the following line rates for uplink traffic and backplane forwarding:
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
