Chapter 3 Installing and Configuring Route Switch Processors and Supervisor Engines
Connecting to the Uplink Ports
Supervisor Engine 2
In addition to the above configuration requirements, note that with a Supervisor Engine 2 you can use two types of console cables to connect a terminal to the console port. To accommodate either type of cable, set the console port mode switch (to the right of the console port) as follows:
•To use the
•To use a Catalyst 5000 Supervisor Engine III console cable and adapter (not provided), make sure that the console port mode switch is in the out position, and use the appropriate adapter for the terminal connection. See the “Console Port Mode 2 Signaling and Pinouts (Sup2 Only)” section on page
Note To access the console port mode switch, use a ballpoint pen tip or other small, pointed object.
Connecting a Modem
To connect a modem to the console port, observe the following guidelines:
•Use the
•On a Supervisor Engine 2, make sure that the console port mode switch is in the in position (factory default).
Connecting to the Uplink Ports
The supervisor engine and route switch processor have uplink ports that you use to connect the router to other network devices. You can configure the ports with small
Table
Warning Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or view directly with optical instruments. Statement 1051
Caution Do not remove the plugs from the optical bores on the
| Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide |
