Cisco Systems 7600 manual 2-16, Supervisor Engine 2 LEDs continued

Chapter 2 Route Switch Processors and Supervisor Engines

Supervisor Engine 2

Table 2-5	Supervisor Engine 2 LEDs (continued)
LED		Color	Description
SYSTEM1		Green	All chassis environmental monitors are reporting OK.
		Orange	The power supply or power supply fan failed.
			Incompatible power supplies are installed.
			The redundant clock failed.
			One VTT2 module has failed or the VTT module temperature minor
			threshold has been exceeded.3
		Red	Two VTT modules failed or the VTT module temperature major
			threshold has been exceeded.3
			The temperature of the supervisor engine major threshold has been
			exceeded.
CONSOLE		Green	The supervisor engine is operational and active.
		Orange	The supervisor engine is in standby mode.
PWR MGMT1		Green	Sufficient power is available for all modules.
		Orange	Sufficient power is not available for all modules.
SWITCH LOAD		-	If the system is operational, the switch load meter indicates (as an
			approximate percentage) the current traffic load over the backplane.
PCMCIA		-	The PCMCIA LED is lit when no PCMCIA card is in the slot and goes
			off when you insert a card.
LINK		Green	The port is operational.
		Orange	The link has been disabled by software.
		Flashing	The link is bad and has been disabled due to a hardware failure.
		orange
		Off	No signal is detected.

1.The SYSTEM and PWR MGMT LED indications on a redundant supervisor engine are synchronized to the active engine.

2.VTT = voltage termination. The VTT module terminates signals on the system switching bus.

3.If no redundant supervisor engine is installed and there is a VTT module minor or major overtemperature condition, the system shuts down.

	Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
2-16	OL-10100-04