Cisco Systems 7600 manual Safety Precautions for Module Installation and Removal

Contents

		Supervisor Engine 2 2-14
		Installing and Configuring Route Switch Processors and Supervisor Engines 3-1
C H A P T E R 3
		Preparing for Installation or Removal				3-1
		Safety Precautions for Module Installation and Removal 3-2
		Preventing Electrostatic Discharge Damage 3-2
		Tools Required for Module Installation 3-3
		Determining Module Location			3-3
		Installing a Supervisor Engine or Route Switch Processor					3-4
		Removing a Supervisor Engine or Route Switch Processor					3-7
		Hot Swapping (OIR) Modules		3-8
		Removing and Replacing Memory				3-8
		Connecting to the Console Port			3-9
		Connecting a Terminal		3-9
		Connecting a Modem		3-10
		Connecting to the Uplink Ports			3-10
		Using Flash Memory Cards		3-12
		Installing a Flash Memory Card				3-13
		Removing a Flash Memory Card				3-14
		Power Management and Environmental Monitoring 3-14
		Determining Software Feature Support 3-14
		Configuring a Supervisor Engine or Route Switch Processor					3-14
		Technical Specifications
A P P E N D I X	A		A-1
		Module Specifications	A-1
		Regulatory Standards Compliance				A-1
		Cable and Connector Specifications
A P P E N D I X	B					B-1
		Limiting Connection Distances			B-1
		Uplink Port Transceiver Modules			B-2

	1GE Uplink Ports and Cabling Specifications		B-3
	10GE Uplink Ports and Cabling Specifications		B-5
	GBIC Module Cabling Specifications	B-6
	Console Port Cabling Specifications and Pinouts		B-6
	Console Port Cabling Specifications	B-6
	Console Port Signals and Pinouts B-7
	Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
iv			OL-10100-04