Cisco Systems 7600 manual Determining Module Location, Tools Required for Module Installation

Chapter 3 Installing and Configuring Route Switch Processors and Supervisor Engines

Determining Module Location

•Avoid contact between the printed circuit boards and clothing. The wrist strap only protects components from ESD voltages on the body; ESD voltages on clothing can still cause damage.

•Never attempt to remove the printed circuit board from the metal carrier.

Caution Periodically check the resistance value of the antistatic strap. The measurement should be within the range of 1 and 10 megohms (Mohms).

Tools Required for Module Installation

These tools are required to install modules in the Cisco 7600 series router:

•Flat-blade screwdriver

•Antistatic wrist strap or other grounding device

•Antistatic mat or antistatic foam

Determining Module Location

Determine which chassis slot to install the module in. Table 3-1lists the chassis slots in which you can install a supervisor engine or route switch processor.

Table 3-1 Supervisor Engine and Route Switch Processor Slot Assignments

Module	Slot Assignments
Route Switch Processor 720	•	Slots 1 and 2 (3-slot enhanced [-S] chassis
(RSP720-10GE)		and 4-slot chassis)
	• Slots 5 and 6 (6-slot and 9-slot enhanced [-S]
		chassis and 9-slot chassis)
	• Not supported in the 3-slot, 6-slot, or 13-slot
		chassis
Route Switch Processor 720	•	Slots 1 and 2 (4-slot chassis)
(RSP720)	•	Slots 5 and 6 (6-slot and 9-slot chassis,
		including enhanced [-S] chassis)
	• Slots 7 and 8 (13-slot chassis)
	• Not supported in the 3-slot chassis
Supervisor Engine 720	•	Slots 1 and 2 (3-slot and 4-slot chassis)
(Sup720)	•	Slots 5 and 6 (6-slot and 9-slot chassis)
	• Slots 7 and 8 (13-slot chassis)

Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide

OL-10100-04 3-3