Cisco Systems ATA 188 LBRCodec, CallerIdMethod, page DNS1IP, page DNS2IP, page Domain, page, 5-11

Chapter 5 Parameters and Defaults

Operating Parameters

•CallerIdMethod, page 5-14

•DNS1IP, page 5-15

•DNS2IP, page 5-16

•Domain, page 5-16

•NumTxFrames, page 5-17

•UDPTOS, page 5-17

•OpFlags, page 5-17

•VLANSetting, page 5-18

LBRCodec

Description

This parameter is used for selecting the low-bit-rate codec. The following values are valid:

•0—Select G.723.1 as the low-bit-rate codec (available only for connections 0 and 2).

•3—Select G.729A as the low-bit-rate codec (available only for connection 0).

If LBRCodec=0, then both Cisco ATA FXS ports can operate with the following codecs:

•Number of codecs=3

•Codec[0]=G.711µ -law

•Codec[1]=G.711A-law

•Codec[2]=G.723.1

If LBRCodec=3, check the setting of bit 21 in the ConnectMode parameter (see the “ConnectMode” section on page 5-13) to determine if G.729 is enabled for the Phone 1 or Phone 2 FXS port.

If LBRCodec=3, then the Phone 1 FXS port can operate with the following codecs:

•Number of codecs=4

•Codec[0]=G.711µ-law

•Codec[1]=G.711A-law

•Codec[2]=G.729 (only if Bit 21 of the ConnectMode parameter is set to 0)

•Codec[3]=G.729A

If LBRCodec=3, then the Phone 2 FXS port can operate with the following codecs:

•Number of codecs=3

•Codec[0]=G.711µ-law

•Codec[1]=G.711A-law

•Codec[2]=G.729 (only if Bit 21 of the ConnectMode parameter is set to 1)

Value Type

Integer

Range

0 or 3

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SCCP)

Ol-3141-01 5-11