Cisco Systems ATA 186, ATA 188 manual CallerIdMethod, Bit Number, Definition, Description, 5-14

Chapter 5 Parameters and Defaults

Operating Parameters

Table 5-2 ConnectMode Parameter Bit Definitions (continued)

Bit Number	Definition
8-12	Specifies the fax pass-through NSE payload type. The value is the offset to the NSE payload base number of
	96. The valid range is 0-23; the default is 4.
	For example, if the offset is 4, the NSE payload type is 100.
13	0—Use G.711µ-law for fax pass-through codec.
	1—Use G.711A-law for fax pass-through codec.
14-15	0—Use fax pass-through.
	1—Use codec negotiation in sending fax.
	2,3—Reserved.
16-20	Reserved.
21	0—Enable G729 on the Phone 1 FXS port.
	1—Enable G729 on the Phone 2 FXS port.
22-27	Reserved.
28-29	0—Select the Cisco ATA Style for mid-call services. Services are call hold/resume, call transfer and
	conference call.
	1—Select the Bellcore Style for mid-call services. Services are call transfer and conference call.
	2—Select the Cisco VG248 Style for mid-call services. Services are three-way calling, call transfer and
	conference call.
	For end-user procedures of each service that the Cisco ATA supports for each style, see Appendix A, “How
	to Use Pre-call and Mid-call Services.”

300/1—Disable/enable Cisco IOS Telephony Solution (ITS). Cisco ITS runs on an IOS router and is a subset of Cisco CallManager. If you have Cisco ITS, refer to the documentation for that product.

310 - Disable XML configuration file support (use if you are running Cisco CallManager version 3.0).

1 - Enable XML configuration file support (use if you are running Cisco CallManager version 3.1 or later).

CallerIdMethod

Description

This 32-bit parameter specifies the signal format to use for both FXS ports for generating Caller ID format. Possible values are:

•Bits 0-1 (method)—0=Bellcore (FSK), 1=DTMF, values 2 and 3 are reserved. If method=0, set the following bits:

•Bit 3 to 8—Use these bits for setting the maximum number of digits in the phone number portion (valid values are 1 to 20).

•Bit 9 to 14—Use these bits for setting the maximum number of digits in the name number portion (valid values are 1 to 20).

•Bit 15—Use special character O.

•Bit 16—Use special character P.

If method=1, set the following bits:

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SCCP)

5-14 Ol-3141-01