Cisco Systems ATA 188 DNS1IP, Examples, Value Type, Default, Voice Configuration Menu Access Code

Chapter 5 Parameters and Defaults

Operating Parameters

•Bits 3-6—These bits are for the Start digit (valid values are 12 for “A,” 13 for “B,” 14 for “C,” and 15 for “D.”).

•Bits 7-10—These bits are for the End digit (valid values are 11 for “#,” 12 for “A,” 13 for “B,” 14 for “C,” and 15 for “D.”).

•Bits 11—This bit is for setting polarity reversal before and after the Caller ID signal (value of 0/1 disables/enables polarity reversal).

•Bits 12-16—These bits are for the maximum number of digits in the phone number (valid values are 1 to 20).

Examples

The following examples are recommended values for the CallerID Method parameter:

•Sweden=0x0ff61

•Denmark=0x0fde1

•USA=0x19e60

Value Type

Bitmap

Default

0x00019e60

Voice Configuration Menu Access Code

316

DNS1IP

Description

This parameter is for setting the primary domain name server (DNS) IP address, if the DHCP server does not provide one. If DHCP provides DNS1IP (and if it is non-zero), this parameter overwrites the DHCP-supplied value. You cannot specify a port parameter. The Cisco ATA uses the default DNS port only.

Value Type

IP address

Default

0.0.0.0

Voice Configuration Menu Access Code

916

Related Parameter

DHCP, page 5-6

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SCCP)

Ol-3141-01 5-15