Chapter 3 Installing the Router
IOS Software Configuration for the Router
3-42
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03
RP Interfaces Using the RP LEDs
Two types of RPs are available for Cisco 12006 and Cisco 12406 Routers: the
Gigabit Route Processor (GRP) and the Performance Route Processor (PRP).
Each of these route processor types is reviewed in the following sections:
• GRP Interfaces Using the GRP LEDs, page 3-43
• PRP Interfaces Using the PRP LEDs, page 3-44
Note When not explicitly specified, this publication uses the term route processor (RP)
to indicate either the GRP or the PRP.
The RJ-45 port LEDs on the RP indicate the following conditions:
• System and RP status
• Which Flash memory card slot is active
• Which Ethernet connection is in use
• What is occurring on the Ethernet interface
The alphanumeric LED displays indicate a successful RP boot.
RP
UP
A valid Cisco IOS image is running. RP IOS
software
PRI
RP
The RP is enabled and recognized as the system primary.
A valid Cisco IOS image is running.
RP IOS
software
SEC
RP
The RP is enabled and recognized as the system
secondary. A valid Cisco IOS image is running.
RP IOS
software
1. The version of MBus microcode running on your system might be different.
Table 3-12 LED Display Meaning and Signal Source (continued)
LED
Display Meaning Source