Cisco Systems Cisco 12006, Cisco 12406 manual Installing the Blower Module

Chapter 6 Maintaining the Router

Removing and Replacing a DC PDU

Step 8 Install the blower module (Figure 6-24):

a.Position the alignment holes on the blower module with the guide pins on the chassis and PDU.

b.Slide the blower over the guide pins toward the chassis until it mates with the backplane connector.

Caution To prevent damage to the connectors, do not use excessive force when installing the blower module.

c.Tighten the (4) captive screws to secure the blower module to the chassis.

d.Lower the carrying handle to its operating position.

Figure 6-24 Installing the Blower Module

1 2

3

129402

	Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03		6-43