Cisco Systems Cisco 12006, Cisco 12406 - page 321

A-3
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03
Appendix A Technical Specifications
Specifications
The electrical specifications and values listed in Table A-2 are for a system
equipped with the AC-input power distribution unit (PDU) and AC-input power
supply modules.
Caution To ensure that the chassis configuration complies with the required power
budgets, use the on-line power calculator. Failure to properly verify the
configuration may result in an unpredictable state if one of the power units fails.
Contact your local sales representative for assistance.
The electrical specifications and values listed in Table A-3 are for a system
equipped with the DC-input PDU and DC-input power entry modules (PEMs).
Tab l e A-2 AC-Input Power Supply Electrical Specifications
Description Value
Rated input voltage1
1. For each AC-input power supply module.
100–120 VAC nominal (range: 85 to 135 VAC)2
200-240 VAC nominal (range: 180-264 VAC)
220–240 VAC (UK)
2. Original series only. 110 V AC is not supported on enhanced series.
Rated input line frequency150/60 Hz nominal (range: 47 to 63 Hz)
50/60 Hz UK
Input current rating113A @ 200-240 VRMS per line cord (max)
Source AC service
requirement1
20A North America; 16A international; 13A UK
Nominal output voltage
and current
-54.5VDC @ 30A maximum (original series)
-54.5VDC @ 36A maximum (enhanced series)
Total AC input power 1708 VA (original series)
2210 VA (enhanced series)
Redundancy 2 AC-input power supply modules are required
for 2N redundancy