Chapter 6 Maintaining the Router
Removing and Installing a Clock and Scheduler Card, Switch Fabric Card, or Alarm Card
6-58
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03
Figure 6-32 Removing and Installing a Clock and Scheduler Card
Removing a Clock and Scheduler Card
To remove a clock and scheduler card, see Figure 6-32 and follow these steps:
Step 1 Attach an ESD-preventive strap to your wrist and connect the leash to the chassis
or to another grounded, bare metal surface.
Step 2 Loosen the two captive screws on each side of the CSC.
Step 3 Grasp the card ejector levers and pivot them away from the CSC faceplate.
Step 4 Slide the CSC halfway out of the slot, then stop.
Step 5 Touching only the metal card carrier, use your free hand to support the bottom of
the CSC.
1CSC 3Ejector lever (2)
2Captive screw (2)
101409
SLOT-0
GIGABIT ROUTE PROCESSOR
SLOT-1
COLL
LINK
TX
RX
RJ-45
MII
RESET
AUX
EJECT
CONSOLE
CISCO 12000
SERIES
GIGABIT SWITCH ROUTER
CISCO 12000
SERIES
GIGABIT SWITCH ROUTER
1
2
3